The GUN Forum

Find answers, ask questions, and connect with our
community around the world.

home Forums – The GUN Forum Firearms Handguns MOS Optic Cuts–Locktite?

  • MOS Optic Cuts–Locktite?

     Mateo updated 11 months, 1 week ago 2 Members · 2 Posts
  • Mateo

    Member
    June 14, 2021 at 3:46 am

    I feel really dumb asking this question, but I’ve googled and searched Reddit for this answer and cannot find it.

    I am trying to replace the optics plate on my Glock 40. My initial effort was frustrtated. I was worried about stripping the screws. On a previous firearm, I had to send it back to the manufacture when installing a similar optic for exactly that reason.

    So, do I man up and push? Or do I need to heat this bad boy up to melt locktite? Or is there a Secret Glock Society solution everyone is hiding from me?

    Thanks and appreciate everyone’s patience and advice in advance.

  • EngineerAl3x94

    Guest
    June 14, 2021 at 3:46 am

    It should come right out. They’re not very tight. I’ve hade 0 issues with my Gen 5 MOS’s. Just make sure you use the right torx or Allen key.

Viewing 1 - 2 of 2 replies
Reply to: Mateo
Your information:

Cancel
Start of Discussion
0 of 0 posts June 2018
Now