The GUN Forum

Find answers, ask questions, and connect with our
community around the world.

home Forums – The GUN Forum Firearms Handguns Safety plunger/ trigger bar engagement

  • Safety plunger/ trigger bar engagement

     Mateo updated 1 year ago 2 Members · 3 Posts
  • Mateo

    Member
    May 18, 2021 at 6:23 pm

    Glock 23
    When the trigger bar is engaging the safety plunger is it supposed to be in the middle of the plunger or is it okay to be riding on the side closer to the rail

    I went to clean my gun when I noticed this and was just curious if it’s something I need to look into I did just install a boogeyman custom excommunicado trigger with the stealth upgrade so it is a new bar

  • voyager40

    Guest
    May 18, 2021 at 6:23 pm

    It’s normal. It’s the reason Glock added a bump of metal to the side of that cam arm on Gen4 and 5 trigger bars but Gen3 trigger bars still work fine. You can use a Gen4 trigger bar in a Gen3 if you want.

    I think the only reason they didn’t add it to Gen3 trigger bars is to keep Gen3’s on CA’s roster of “permitted handguns”. Any significant design change would knock them off the roster and they’d never be able to get back on.

  • GB0055

    Guest
    May 18, 2021 at 6:23 pm

    The trigger bar extensions ride off center of the trigger safety plungers

    The Gen 4 trigger bars added the bump/spacer to allow the magazine to not bind the trigger bar when the mag catch is switched to the left hand configuration.

Viewing 1 - 3 of 3 replies
Reply to: Mateo
Your information:

Cancel
Start of Discussion
0 of 0 posts June 2018
Now